New release of Autocat+ now available

Printable version 25 September 2009

We are pleased to announce the release of Autocat+ v5 r2.2. This latest revision includes a new failback procedure that will automatically switch to our Tankersley backup servers should a problem arise with the primary servers in Liverpool.

To ensure you have the most up-to-date software, please follow the instructions below:

1. Start Autocat+ and check the version by pressing F12. The seventh line down should read Ver 5, Revision = X.X:
2. 
3. If the Version is less than 5 and/or the Revision number is less than 2.2, follow the instructions below.
4. Press F11. You should see the following prompt:
5. 
6. If you do not see the above message, please wait 30 seconds then re-try.
7. Quit out of Autocat+ completely. You should see a download message:
8. 
9. Once the download has completed, you should see the following prompt:
10. 
11. Re-start Autocat+ and check the version by pressing F12. The seventh line down should read Ver 5, Revision 2.2 or higher:
12. 

This procedure needs to be undertaken for every installation of Autocat

If you experience any problems with this procedure, please contact the support department on 01226 352903